Hospital Bed
- L Length
- W Width
- H Height
Length runs head to foot, width side to side, and height from the floor to the mattress platform. Adjustable beds may list a height range.
A practical reference to understand dimensions, terminology and sizing across our surgical instruments and hospital furniture.
Measurement terms
Not every measurement applies to every product. Each listing shows the dimensions that are relevant to that item.
The longest dimension, measured end to end. For an instrument, usually the overall tip-to-handle length.
Measured side to side. For instruments, usually the jaw, blade or working-end width, where stated.
The depth of a material, blade or sheet, such as stainless-steel sheet or a chisel blade.
The distance across a round part, such as a rod, tube, cannula, drill or bur.
The front-to-back size of furniture and equipment, such as a locker, cabinet or trolley.
Surgical instruments
Common measurement points for instruments such as forceps, scissors, clamps and needle holders. The drawing is illustrative and not to scale.
Measurement points differ by instrument design and model. Always refer to the individual product specification for exact dimensions.
Conversion
1 inch = 2.54 cm (exact)
| Inches | cm | Inches | cm |
|---|---|---|---|
| 1″ | 2.54 | 7″ | 17.78 |
| 2″ | 5.08 | 8″ | 20.32 |
| 3″ | 7.62 | 9″ | 22.86 |
| 4″ | 10.16 | 10″ | 25.40 |
| 5″ | 12.70 | 11″ | 27.94 |
| 6″ | 15.24 | 12″ | 30.48 |
Listings may round measurements, so a 6″ instrument may appear as 15 cm or 15.2 cm.
Hospital furniture
The drawings show where each measurement is taken. Sizes vary by model, so no figures are given here; check the individual product listing for exact dimensions.
Length runs head to foot, width side to side, and height from the floor to the mattress platform. Adjustable beds may list a height range.
Width across the front, depth from front to back, and height from the floor to the top surface.
Length and width of the top shelf, and height from the floor to the top shelf.
Overall top length, width side to side, and height from the floor to the top surface.
Illustrative diagrams, not to scale. Please refer to the individual product listing or contact our team for the exact dimensions of a specific model.
Before you order
Sizes can differ between models and variants of the same product type.
Read the full length, width and height shown on the product page.
For instruments, compare jaw, blade or tip sizes where they are listed.
Measure the room or bay where the furniture will be used.
Allow for doorways, lifts and corridors for furniture deliveries.
If a measurement matters, contact our team before ordering.
Questions
Most instruments are listed by overall length, measured from the tip to the end of the handle or rings. Where relevant, a listing may also give the jaw or working-end length, the jaw or blade width, or a diameter. Measurement points vary with the instrument’s design, so check the individual product specification.
One inch equals exactly 2.54 centimetres. For example, 6 inches is 15.24 cm, which a listing may round to 15 cm or 15.2 cm.
Length is measured from the head end to the foot end, width from side to side, and height from the floor to the mattress platform. Adjustable beds may list a height range. Use the exact model’s specification for the figures.
No. Dimensions vary by model and configuration, which is why the diagrams on this page show where each measurement is taken rather than fixed sizes.
On the individual product page, where they are listed. If a dimension is not shown or is critical for your use, send an enquiry and our team will confirm it for the exact model.
Browse products
Our product specialists can help you understand measurements, specifications and available models.